La Bringa kerékpárbolt és szerviz - La Bringa kerékpárbolt és szerviz

I highly recommend you guys. I have been there several times, always leaving satisfied. Thanks and I'll go next time.

They were quick to help me after an annoying puncture. You guys are kind, helpful and fast, I recommend them!

Professionalism, fast work and most of all quality, long-lasting work! When it comes to bikes, just here! Special thanks to Tom for the atmosphere!

I just went in today to inquire and got tips and advice on buying a bike like never before. The seller was very helpful! I can only recommend the place.

I am very happy with them! They are kind, helpful. I repaired a Strida folding bike with them. Not the kind of bike there are dozens of in the country. Yet all the problems were perfectly solved on my bike. Thanks! I was with them for the first time about a year ago, and since then I have taken them to them with any problems.

After replacing the back row on my bike, they “forgot” to put the dust cover on the plastic disc back. The dust cap on the steering bearing is also "left behind". The ricnis screw on the rear row cassette was tightened so that it could not be pulled apart with a 180 Nm impact screwdriver. At the rear bearing, the screw was torn so that it could not be disassembled for the time being. When I brought it back earlier that the rear bearing was bouncing and could not be disassembled, they were hesitant, "that this has to be put together so tightly, because otherwise it will fall apart." After that, the rear bearing was "supposedly" made. I can see that the bearing balls have been replaced, but in the same way, the bolts on the adjusting side and on the other side have been "snorted" to be together again and look good now. The damage has so far been approx. HUF 10 thousand: complete rear bearing replacement + spoke. I didn’t think it was so literally meant that tuition had to be paid. I gave it a star because it can't be zero. In response to the answer: I have a cartridge remover, a 21-gauge wrench, a 17-inch open-end wrench, and so on. I get it, I just never have time for anything again. (I also always write late at night). I tried everything step by step until we got to the impact driver. For 12 years, while I was assembling the bike, it was always interesting to disassemble everything with a set of carbon steel wrenches. YOU PULL THE CASSETTE (the blond child with the voice of Bellus István) so that it could only be disassembled with the neighbor's 400 Nm impact screwdriver. And yes, I’m going to replace the shaft (then ...) and then I’ll bring it in to you, slam it down on the table and tell you to unscrew the cone and the adjusting screw in front of my nose! And I don’t take the bike there anymore in my life. Of course, to ruin something else on it. ..